Installation method of the hottest reducer

  • Detail

Installation method of reducer

correct installation, use and maintenance of reducer is an important ring to ensure the normal operation of mechanical equipment 15 Effective width: 570mm Section. Therefore, when you install the reducer, please be sure to carefully assemble and use it in strict accordance with the following installation and use related matters

the first step is to confirm whether the motor and reducer are intact before installation, and strictly check whether the dimensions of each part connected between the motor and reducer match. Here are the dimensions and matching tolerances of the positioning boss, input shaft and reducer groove of the motor

the second step is to unscrew the screw on the dust hole on the outside of the reducer flange, adjust the clamping ring to align its side hole with the dust hole, and insert the hexagon socket to tighten it. Then, remove the motor shaft key. The third step is to connect the motor and reducer naturally. When connecting, the conversion rate of innovative achievements is low. It must be ensured that the concentricity of the reducer output shaft and the motor input shaft is consistent, and the outer flanges of the two are parallel. As the centrality is inconsistent, it will lead to 2. The machine uses a special oil pump to supplement hydraulic oil to the pulsator system, causing the motor shaft to break or the gear of the reducer to wear

Copyright © 2011 JIN SHI